Редактирование: AI (раздел)

=== Step Two: Preparing the Cooling Loop ===
1. Color Code: Orange. Turn on the "Atmospherics to Loop" Pressure Valve, do not edit the kPa (for now)

'''WHY:''' This is the pump that lets in the gas from Step One to enter the Cooling Loop, it is left at 101 kPa for the same reasons that the Pressure Valves in Step One are, but in the case of a hot gas delamming emergency cranking up the outlet kPa limit to let in more cooling gas is perfectly fine.

2. Color Code: Green. Turn on all of these Valves/Filters, set them to maximum kPa/Volume, if they're Gas Filters have them filter nothing.

'''WHY:''' The specifics of each pressure valve/filter is covered at detail in The Guide to the [[Guide to the Supermatter|Supermatter]], The summary is that we want to maximize the gas flow throughout the entire loop to improve the cooling of the Engine and maximizing the kPa outlet limit aids in this by allowing higher volumes of gas to pass through until the outlet pipenet hits the set kPa limit. The highlighted green Filters do not serve any purpose filtering any gas and so should be set to nothing.

3. Color Code: White. Turn on the Filter, set it to filter N2 

'''WHY:''' This filters out whatever gases we don't want to remain in the Cooling Loop, such as combustible O2 with Plasma as the fuel. The reason why this is the only filter we set to filter anything in the line of waste filters, is because it will get rid of the waste gases before it reaches the other filters.

4. Color Code: Red. Turn off this pressure valve.

'''WHY:''' This is a bypass intended to allow you to have the gases flow around the cooling loop without entering the chamber, but it is a detriment when the engine is running, due to joining the cooled gas input pipenet and heated gas output pipenet.

4. Color Code: Yellow. Set the Scrubbers to Expanded + Siphoning, set the Vents to internal kPa 0

'''WHY:''' Expanded makes it so that the Scrubber drain gas in a 3x3 area centered around itself as opposed to 1x1, Siphoning makes it grab every gas which we want so as to take out heated gas from the chamber and cool it in the loop. Internal kPa 0 makes it so that the Vent will try to fully empty the input pipenet, these settings maximizes the amount of cooled gas coming in and heated gas coming out.

5. Color Code: Light Blue '''(Optional)'''. Turn on the Freezers, set them to the lowest possible temperature.

'''WHY:''' This is necessary on a map like Ice Box due to the Planetary snowy environment cooling less efficiently than the Freezers, but on a Space Station map the Freezers are less efficient than the void (which can cool down to 22 Kelvin), and so it mainly just functions as extra safety.